![active sky 16 asconnect error active sky 16 asconnect error](https://docplayer.net/docs-images/40/12307672/images/page_14.jpg)
This is the first time I've had any control "problems" with it. as well as some of the other "fixes" it can do. I don't set up my controls with FSUIPC, but I do usually set it to remove "spikes" and to set end points, etc. Took me a few tests to find, and attribute it to FSUIPC, as I never had any problem with prior editions. do you and Thunderstreak have FSUIPC 6 installed? I ask because I was having major problems with control surfaces not working, or only partially moving on P3Dv4.5HF3 and P3Dv5 wo/w HF1. 1061 views today and not a single answer. I posted a message on the LM forum on May 08. A jet stream at an altitude of 200 'is not common isn't it? I realized that the phenomenon does not appear if I stay below 200 '. I have a few more planes working but I don't dare to add any more. I am on the fourth reinstallation of P3Dv5.
ACTIVE SKY 16 ASCONNECT ERROR INSTALL
I install the plane with which the problem appeared and again the tornado. Without any addons, scenery or planes, it works normally. I then installed the v5 on another hard drive. 4 A2A planes and an Alabeo which is my default plane. I followed the same procedure, removed the last downloaded addons, went to HF3 but without results, I can only use 5 planes of the whole (almost 100). With Win10, P3Dv4.5, it happened suddenly. I have had exactly the same problem as you since May 02.